DarwinBotsManual
Open the app EspañolES

.eye4

The eye centered 10 degrees to the left of the front: 0 if it sees nothing, and the closer what it sees, the higher the value.

Facts

Address
504
Name
.eye4
Kind
Sense: the engine writes it for the DNA to read
Group
Eyes
Written by
The engine, in the actions phase of every cycle, with what the eye that looks 10 degrees to the left by default sees. You read it in the next cycle.
Cleared
The engine, every cycle, before looking again: if the eye sees nothing, it stays at 0.
Range
0 to 32000: 0 means seeing nothing, 1 is the edge of the range and 32000 is touching.
Mutations
picked as a read (*)

One of the bot's nine eyes. With the factory configuration it looks 10 degrees to the left of .aim, with a field of 10 degrees. It sits between .eye3 and .eye5. It is 0 if it sees nothing, and if it sees something, a number that grows as it gets closer: 1 at the edge of the range, 100 at about 134 units edge to edge and 32000 when they touch (the table is in Eyes).

Like all the eyes, it is written by the engine at the end of the cycle, so what you read is what was seen after the last movement. It can be pointed elsewhere with .eye4dir and widened with .eye4width; if you widen it, it doesn't see as far and gives smaller numbers at the same distance.

A typical use of the side eyes is to turn toward what they see to bring it in front of .eye5. 10 degrees is about 35 units of .aimsx:

' something on the left and nothing ahead: turn toward it
cond
*.eye4 0 >
*.eye5 0 =
start
35 .aimsx store
stop