DarwinBotsManual
Open the app EspañolES

.hitup

It is 1 in the cycle after a head-on collision, with something that was in front of the bot.

Facts

Address
205
Name
.hitup
Kind
Sense: the engine writes it for the DNA to read
Group
Collisions and hits
Written by
The engine, in the forces and collisions phase: 1 if what it touches is in front, within about 45 degrees of its heading. You read it in the next cycle.
Cleared
The engine, when the senses are cleared, right after your DNA.
Range
0 or 1.
Mutations
picked as a read (*)

.hitup turns on when the bot collides with something in front of it: the center of the other one falls inside a cone of about 45 degrees on each side of its heading (.aim). It is one of the four directions of .hit, along with .hitdn (behind), .hitdx (right) and .hitsx (left); .hit turns on whenever any of them does.

Like all touch, the engine writes it in the physics step and your DNA reads it in the next cycle, only once: after that it is cleared.

A head-on collision is usually what the bot was looking for (or what it bumped into for not looking). What it touched is described in the ref* sysvars, so the bot can react depending on what it is. This bot backs off if what is in front of it is bigger than it is:

cond
*.hitup 0 !=
*.refbody *.body >
start
30 .dn store
stop