DarwinBotsManual
Open the app EspañolES

.mass

The bot's mass: it comes from the body, the shell and above all the chloroplasts, and decides how much each push moves it.

Facts

Address
10
Name
.mass
Kind
Sense: the engine writes it for the DNA to read
Group
Body, energy and state
Written by
The engine, in the movement phase, before the purchases and conversions of the actions phase. You read it in the next cycle.
Cleared
No: the engine rewrites it every cycle.
Range
1 to 32000; it comes from the body, the shell and above all the chloroplasts.
Note
A freshly loaded bot reads it as 0 in its first cycle.
Mutations
picked as a read (*)

Mass is how much the bot weighs for the physics. A heavier bot accelerates less with the same push from .up, is harder to stop and, if there is gravity, falls harder (see Physics).

It comes from three things:

WhatHow much it weighs
.body1 per 1000 of body
.shell1 per 200 of shell
.chlralmost 1 per chloroplast (0.99)

The difference is huge: a typical bot, with 1000 of body, weighs 1, but as soon as it buys 500 chloroplasts it weighs about 500. That is why a bot loaded with chloroplasts responds very little to its own pushes. The value never drops below 1 nor goes above 32000.

It is read one cycle late, and besides, the engine computes it before applying the cycle's purchases and conversions: if you buy chloroplasts, the new mass only shows up two cycles later. A freshly loaded bot reads it as 0 in its first cycle.

' If it weighs too much, it sheds chloroplasts
cond
 *.mass 100 >
start
 100 .rmchlr store
stop

See also .mkchlr and .rmchlr.