DarwinBotsManual
Open the app EspañolES

.tielen1

Length of a multicellular bot's first tie, edge to edge; writing it sets that tie's natural length.

Facts

Address
484
Name
.tielen1
Kind
Input and output: both the bot and the engine write it
Group
Ties
Written by
Your DNA and the engine. Writing it with store (or another two-operand store) sets the natural length of the first tie, signed, in the movement phase; after that the engine writes the measured length, which you read in the next cycle.
Cleared
The engine rewrites it every cycle, only if you are multicellular, the first tie is stiffened and .tienum or .tiepres is not 0.
Range
from about −240 (overlapping bots) up to 32000
Mutations
picked as a read (*) and as a store target

It is a read-write cell for the bot's first tie (the oldest one it has left; if one breaks, the following ones shift up a slot), and it only works if the bot is multicellular (.multi) and that tie is stiffened.

Reading. Every cycle the engine publishes the distance to the partner minus the two radii. It is measured before the bots are moved, so it can differ a little from .tielen.

Writing. A value written with store (or with another two-operand store) becomes the natural length of the tie, edge to edge, for both ends, just like .fixlen but without picking the tie with .tienum. Unlike .fixlen, here the sign counts: a negative asks the bots to overlap. Afterwards the engine writes the measurement back into the cell. With inc or dec the tie doesn't find out (see Writing to memory).

If the bot isn't multicellular or the first tie isn't stiffened, the engine doesn't touch the cell. It doesn't touch it either if .tienum and .tiepres are both 0.

' keep the first tie at 150
cond
*.multi 1 =
start
150 .tielen1 store
stop

With a child tied to its parent, once the tie is stiffened the distance goes from almost 0 to about 150: it overshoots at first and then ends up oscillating between about 115 and 175. The angle of the same tie is .tieang1.