DarwinBotsManual
Open the app EspañolES

.velup

The part of the bot's velocity that goes forward, in the direction it points; negative if it moves backward.

Facts

Address
200
Names
.velup, .vel
Kind
Sense: the engine writes it for the DNA to read
Group
Movement
Written by
The engine, in the movement phase, after moving and turning the bot: the forward velocity relative to the new heading. You read it in the next cycle.
Cleared
Nobody; the engine rewrites it every cycle.
Range
Between minus and plus .maxvel; positive forward.
Mutations
picked as a read (*)

.velup (also written .vel) says how much the bot advances in the direction of .aim: positive if it goes forward, negative if it goes in reverse. The sideways part is in .veldx and the total speed in .velscalar. .veldn is the same figure with its sign flipped.

The engine publishes it after moving and turning the bot, so it is measured relative to the new heading. If the bot turns without changing its velocity, the same movement passes from .velup to .veldx: a bot going forward at 40 that turns a quarter turn reads .velup 0 and the whole velocity sideways. In the first cycle of life it is 0.

Its clearest use is braking: pushing against your own velocity.

' brakes: pushes against its own velocity, forward and sideways
cond
*.velscalar 0 >
start
*.velup .dn store
*.veldx .sx store
stop

Since the actual push is a little smaller than the number written, the bot doesn't stop dead: it loses about two thirds of its velocity per cycle and in about four cycles reads 0. The velocity sysvars are rounded to the nearest integer, so a drift of less than half a point per cycle may remain that you can no longer see.